GEMLEAF™ INDOOR DISPLAY LETTERS

DOUBLEFACE TAPE MOUNT

Double sided tape can only be applied to letters up to 24" in height. If using this option then always use a liquid silicon caulk as well to protect the letters in case the tape should fail

PAD MOUNT

Plastic pad extending beyond back of letter, typical with plastic letters, install product direct to wall without having to drill any holes. Installed with use of a spacing guide. Silicone is a common adhesive to hold such letters.

STUD IN BLOCK MOUNT

This is the default stud mount. This option will have blocks glued to the backs of the letters that create a natural surface standoff of about 3/8" which can be enhanced by choosing a standoff length in the forms options. The blocks are drilled and tapped to accept studs(threaded rods) that get glued into holes drilled in the mounting surface.

COMBO MOUNT

The combo or combination mount differs from the combination all mount in that it only has stud THROUGH pads on the tops of the letters and standard PAD mounts on the bottoms. This mount is useful where you want to drill as few holes as possible and still have mounting rods(studs) in the wall. Installed by drilling holes for the stud through pad and adhering non stud pads directly to mounting surface.

COMBO ALL MOUNT

The combination all mount is stud through pad on all points. This gives you adjustability on every stud and is useful for irregular surfaces such as corrugated metal buildings, lap siding, stone walls or anywhere you want a standoff form the wall that is adjustable during installation.

FLUSH STUD MOUNT

Letters have to be at least 3/8" thick to drill and tap the holes but this mount is very secure since it does not rely on a glued block to hold the stud. This mount is best used without wall stand-off which will compromise the purpose of this mount which is to prevent theft. If you want stand-off you can select it also but allow for the stud length which should be 2" in the wall plus the length of the stand-off.