Page Loading....

Montana Lettering Inc, Manufacturing & Distribuor since 2000
cartShopping Cart : $0.00
Product ships from nearest location
Minnesota-Iowa-Virginia-Texas-Nevada


Authorized Dealer for Gemini Sign Products

Tips and Videos to help with Installing Sign Letters

One of the most frequent questions we get is how to install the sign letters. Most people imagine some form of anchor is attached to the wall onto which the letters are mounted. Fortunately, it's not that complicated. Any tools you need you most likely have at home.

Types of Mounts

We sell a wide variety of sign letter products. Each type of letter has its own mounting requirement. There is no "one-method-fits-all." Some sign letters are hollow in the back and require either a stud or pad mounting to properly install. Other letters are solid material, like the flat cut-out acrylic letters and the flat cut-out aluminum letters. Because these letters are solid material and flat on the back, they can be mounted without hardware.

Anchor Type Mounts:

  • Stud Only
  • Combination
  • Combination All
  • Bottom Stud
  • Flush Stud
  • Stud Boss
  • Welded Stud
  • Keyhole Mounts

Installing Sign Letters Using Anchor Mounts

You will need: (a): A long bubble level or better still a laser level. (b) An electric drill and perhaps some masonry drill bits. (c) Something to blow debris from the holes you drill, a turkey baster works well or even the exhaust ports on your drill will often be enough to blow out the debris and (d) Silicon Caulk, Construction Adhesive, Epoxy or whatever your favorite anchoring glue is, to fill all of the holes you drill.

A mounting pattern, is optional, but it will save you a lot of time and almost guarantee a professionally spaced and aligned installation.

 

The Stud Mount

The Combination & Combination all Mount

Adhesive Type Mounts:

  • Pad Mount
  • Flange Mount
  • Double-Sided Tape
  • Direct Adhesion with Silicon Caulk, Epoxy or Construction Adhesive

 

Installing Sign Letters Using Adhesive Mounts

Instructions apply whether you choose pad mounts, adjustable pad mounts or no mounts at all. For no-mount installations on a flat, dry surface, use small drops of silicon caulk on the back of each sign letter. This type of mount works better indoors.

For double-sided tape (tape provided with the letters or by you) use small drops of silicon caulk between the pieces of double-sided tape to ensure against the tape drying out after a period of time and no longer holding the letters.

The Pad Mount

The Tape Mount

 

Mounting Pattern for Sign Letters

Patterns come in several forms depending on the manufacturer of your letters. For stud mounted installations, your pattern will be the actual, full-size of your finished sign. All letters, numbers, punctuation, and logos (if ordered) will be clearly drawn and properly spaced on the pattern. Signs that have multiple lines of text will be aligned to your specifications and all of the required stud locations are marked on the pattern.

For pad mounts or other adhesive based installation methods, you can buy a pounce pattern or use the free spacing tape offered with some of our products. The pounce pattern is a full size, fully aligned and spaced pattern. Instead of it being marked with mounting holes, the letters are drawn on the pattern and perforated around their outer edge. Just tape the pattern in place, rub chalk over the holes to leave a chalk outline on the mounting surface. Install your letters, then wash the off chalk. The free spacing tape only provides spacing information on where to place each sign letter in relation to the one preceding it. Vertical and horizontal alignment will be up to you.

About Mounting Patterns

Mounting to Uneven Surfaces

Mounting with Rails

Mounting on Bricks