Not recommended for the non-professional. This product is hollow in the back and without some form of mount in it will be impossible to mount. Running screws through the face will void the lifetime warranty. Sign Professionals Only!
A flange mount leaves a flat edge of material around the perimeter of the letter where you can run screws through. This kind of mount is often used on corrugated metal buildings and the flabge and mounting screws are painted the color of the building to hid e the flange.
Plastic pads extending about 1/8" beyond the back of letter allow you to use silicon on the pads and glue toa flat surface. Installed with use of a pounce pattern or spacing guide. Not recommended for outdoor installations or uneven surfaces.
This is the default stud mount. This option will have blocks glued in the backs of the letters that accept threaded rods(studs). Drill corresponding holes in the mounting surface using the drilling pattern available at extra cost, then fill the holes and coat the studs with silicon and push the letter to the wall. A drill mounting pattern is required.
The combo or combination mount differs from the combination all mount in that it only has stud THROUGH pads on the tops of the letters and standard PAD mounts on the bottoms. This mount is useful where you want to drill as few holes as possible and still have mounting rods(studs) in the wall. Installed by drilling holes for the stud through pad and adhering non stud pads directly to mounting surface. A drill mounting pattern is required.
The combination all mount is stud through pad on all points. This gives you adjustability on every stud and is useful for irregular surfaces such as corrugated metal buildings, lap siding, stone walls or anywhere you want a standoff form the wall that is adjustable during installation. A drill mounting pattern is required
Has "L" shaped wire loops that protrude at the back side of the letter for your wood screws. Wires can have a stand off or fit flush to wall. Specify standoff if required. Minimum 9" height required
The bracket is similar to the wire mount except the "L" shape is made of plastic. Flush mount only. Minimum 9" height required
Full size Drilling patterns are tracing of letters done by hand at the factory. The letters, with studs screwed into the back or into blocks, are then punched through the paper to show the exact location of the studs. Once taped onto a wall, the hole locations are then drilled and filled with adhesive for any installation using a threaded stud. $3.25 per letter.
A guide for plain, pad or double face tape mounted letters. The letters in a specific copy are spelled out and properly spaced on a long pattern table or computer generated. A narrow (approximately 2") piece of paper contains small hash marks or plotted lower portions of the letters. This guide is then secured to the wall with tape by the installer and provides a visual guide for installing letters. $10 - ANY QUANTITY.
Formed letters and logos with an opaque chrome finish are suitable for interior or exterior applications. Available in single pieces up to 45 inches by 68 inches, the finish is durable and provides the ultimate chrome finish in a deep dimensional letter. These pieces are perfect for automotive businesses, nightclubs and trendy up-scale clients looking to freshen up their brand. Image is everything and these pieces have it. Adds 250% to price
Made with the same UV-stable plastic as the Polished Chrome finish, Brushed Chrome provides a slightly different look that many businesses find appealing. Adds 300% to price
4310 Dove Grey
4660 Desert Sand
2662 Red Orange
1875 Brick Red
2767 Midnight Blue
2050 Dark Blue
2860 Medium Blue
2648 Light Blue
3210 Teal Blue
2108 Light Green
2030 Dark Green
2162 Hunter Green
6371 Yellow Gold
2756 Metallic Gold
3120 Medium Bronze
3130 Duranodic Bronze
8886 Metallic Silver
About Vacuum Formed Plastic Letters, Numbers and Logos from Gemini Sign Products.